PLASTIK Open Joint-Stock Company

Dzerzhinsk 606000, Nizhny Novgorod oblast, Russia phone: 8313 574275, 552444, 335861, 574114, 574205, 574376 Marketing dpt.: 574319, 574316, 574366 Sales dpt.: 574104, 574213, 574203, 574311 fax: 8313 331338, 332959 teletype: 651827 Plast

General Director: Valery Larionov
Commercial Director: Vladimir Smotrizky
Chief Engineer: Victor Volkov

Plastik, an open joint-stock company located in Dzerzhinsk, is set up in 1965. The main incentive of the firm foundation was the Gorgy Auto Plant. The mass production of motor vehicles required the same output of plastic components.

OAO Plastik is focused on production of plastic items and polymer films. The range of the output products includes:

• polyethylene film GOST 10354-82, sleeve shaped, half-sleeve shaped, panel;
• polyethylene stabilisation film: single layer, multi-layer and multi-layer with an additive against sticking;
• thermo-shrinkage polymer film GOST 25951-83 for shaping single items and packing;
• polyethylene film for milk and milk product packing with coloured printing;
• high elasticity film for product packing on European standard pallets;
• polyvinilchloride rigid film for packing of food stuffs, pharmaceuticals, confectioneries, blister packs for consumer goods;
• powder polyvinilchloride (PVC) composition for production of containers for food stuffs;
• granulated plasticates on PVC tar base, including cable;
• sheet PVC plasticate type 57 - 40 for lining of electroplating baths;
• buckled plastic sheets for roofing;
• bags and packs of polyethylene film of various sizes, including with coloured printing;
• glass plastic items, including tubes of various diameters, heaters of specific capacity of 1700 W\m2;
• industrial wiping napkins for motor vehicle body wiping after priming before paint coating;
• gas cleaning units for thermal power stations;
• structured polycarbonade sheets;
• low pressure polyethylene sheets;
• non-plasified plolyvinilchloride sheets (viniplast);
• plastic components produced by extrusion techniques, including blown-out items, thermo-resistant tubes, insulation sleeves, sections etc;
• plastic items produced by moulding techniques under pressure and pressing;
• protection helmets;
• polymer containers, including crates for bottles, crates for milk products, folding crates for vegetables, polyethylene buckets, basins of various volume;
• plastic consumer goods.

The firm’s needs:

• high pressure polyethylene, type 158-03-020, 153-13-130, 153-03-003;
• suspension polyvinilchloride, type C-5868 PJ.